Draining Procedures - Sundance Spas Camdenl Certa Owner's Manual

CAUTION! READ THIS BEFORE DRAININg: To prevent
!
damage to the spa's components, turn off power to the spa
at the circuit breaker before draining it. Do not turn the power
back on until your spa has been refilled. There are certain
precautions to keep in mind when draining your spa. If it is
extremely cold, and the spa is outdoors, freezing could occur
in the lines or the equipment (see "Winterizing", Section 11.7
page 34). On the other hand, if it is hot outdoors, do not
leave the spa's surface exposed to direct sunlight for long
periods.

Draining Procedures:

1. Turn off power to spa at breaker.
2. Locate the 3" gray drain valve cap on side of the
spa cabinet. Unscrew drain valve cap to expose
the underlying male garden hose fitting (fig. G-I).
3. Attach female garden hose end to drain fitting
and route opposite end of garden hose away from
spa (fig. H).
4. Pull outward on garden hose end at drain con-
nection (approx. 3/8") to open drain valve and
release water from spa (fig. I). Water drains at
approximately 3 gallons per minute.
5. After spa has drained, close drain valve by push-
ing inward on garden hose end at drain connec-
tion until you feel it bottom out. Remove garden
hose and install gray drain cap before refilling
spa. Note: The gray drain cap cannot be installed until the drain
valve is closed. Refer to "Spa Fill Up Procedure" (page 15) for rec-
ommended filling instructions.
Page 32
Figure G
Figure H
Figure I
3/8"