Troubleshooting; Declaration Of Conformity For Ce Marking - Charnwood W616 Operating Instructions Manual

Troubleshooting

Saw vibrates
Cuts are slow, wood is blackened
Saw stalls
Tilt and/or blade height difficult to adjust
Rip fence is not parallel to blade
Lower saw guard fills with dust
Motor is running, but blade stationary
When pressing start, nothing happens

Declaration of Conformity for CE Marking

Charnwood Declare that Woodworking Circular Saw, Model W616
Conforms with the following Directives:
And further conforms to the machinery example for which the EC type examination
Certificate No. BM 50166724, AN 50166720 and AE 50243515 have been issued by
TUV Rheinland LGA Products GmbH, Tillystrasse 2, 90431, Nurnberg.
I hereby declare that equipment named above has been tested and found to comply
with the relevant sections of the above referenced specifications. The machinery
complies with all essential requirements of the directive.
Signed:
Richard Cook, Director
Check all nuts and bolts for tightness, check
tilt is locked and check that blade is not
damaged.
Examine the blade. If any carbon tips are
missing or broken the blade should be
replaced. If the tips are blunt, the saw blade
may be professionally sharpened.
Feed rate too high, slow down.
Check tilt lock has been released, clean and
lubricate mechanism.
Bring the fence to a straight line on the table
top. Use a Hex key to undo the 2 adjusting
screws, located in the blue painted section,
and re-align the fence so it is parallel.
It is essential to use a vacuum extractor or
chip collector with this machine. If one is
being used, check for blockages in the hose.
Check the drive belt, replace if broken
Check fuse, check switch, Check carbon
brushes & replace if worn
Machinery Directive 2006/42/EC
Low Voltage Directive 2006/95/EC
EMC Directive 2004/108/EC
Dated: 26/11/2009
13
Location: Leicestershire