Optional Accessories - Charnwood W616 Operating Instructions Manual

Blade Removal and Replacement
Always switch off and unplug the saw before removing or replacing the blade.

Optional Accessories

A section of the table, to the right of the blade is
removable to allow access to the interior of the saw.
Remove the two screws (no. 2 Phillips) and lift out
the panel.
Use a 10mm spanner to hold the spindle stationary
whilst using the 24mm spanner supplied, to unlock
the securing nut. The blade can now be removed.
Reverse this procedure to fit the new blade.
W616ET Right hand Extension Table - An additional
extension table which fits onto the standard table and
increases the maximum ripping width to 700mm (28").
W520 Universal Wheel Base – Allows the saw to be
easily moved around the workshop, simply by pressing
the foot pedals.
W680 Dust Extraction
It is highly recommended that a suitable Vacuum
extractor or Dust collector is used with this Table Saw.
Failure to do so will result in blockages inside the
guarding and hoses. If blockages and built up dust are
not removed it may cause damage and excessive wear
to the saw blade and ultimately the failure of the motor.
This will void the manufacturer's warranty.
11