Charnwood W616 Instructions

Blade Alignment Instructions
1)
Remove the extension tables and leg stand from the saw if fitted.
2)
Lay the saw onto its left hand side and remove the four pozi screws holding
the rubber feet and bottom cover from the machine.
3)
Loosen, but do not remove, the four socket cap bolts indicated, using an 8mm
hex key (or allen wrench). Adjusting the blade will be easier if you leave two
diagonally opposed bolts sufficiently tight to hold the motor in position whilst
still allowing it to slide.
Accessing these bolts is best done with a long reach hex key, or with a socket
set.
4)
By holding the motor it is then possible to align the sawblade in the table slot.
W616 Saw Table
M10 Socket cap bolts holding motor