Table of Contents
Advertisement
USER INTERFACE
INPUT OPERATION
Browse - Touch the arrows ▲ AND ▼ or ◄ AND ► to browse the selections.
Select - Touch your selection on the screen for confirmation.
Start - Touch the
button or touch and hold the operation program for
3 seconds to start the selected program.
Enter - Confirms data and takes you back to the previous screen.
Next - Takes you to the next setting screen.
INITIAL SYSTEMS SETUP
Settings Menu
Before you start using you charger, you may want to adjust the system settings to
your liking. In the System Setup Menu, you can set System Settings, Safety Protec-
tion Settings and Charger Parameters. Use the ◄ and ► to go to the previous or
next system setting and press "NEXT" to enter the selected program menu.
Systems Menu
In the Systems Setting menu, you can adjust a variety of preferences as indicated in
the chart below.
ITEM
SELECTION
KEY BEEP
ON/OFF
Turns On or Off the beeping sound that occurs when you touch a function key.
Turns On or Off the sounds that occur during operation, alerting to different
BUZZER
ON/OFF
mode changes.
LCD LIGHT
1 ~ 5
Adjusts the brightness of the LCD screen.
Blue, Red, Yellow,
THEME
Changes the color scheme of the touch screen inputs.
or Green
ABOUT
-
Displays Model / Serial Numbers and Hardware / Software versions.
RESTORE
YES / NO
Resets Charger to Default Factory Settings.
14
DESCRIPTION
In the Safety Protection Settings Menu, you have the ability to set specific
safety settings to further protect the charger against errors.
You should always check the safety settings prior to starting a
charge or discharge process as the Safety Protection Settings values
are always retained at the last set value.
ITEM
SELECTION
Similar to the Safety Timer, Capacity Cut-Off allows you to limit
OFF
the maximum charge capacity of the charging process. Limiting a
CAPACITY
100-20000 mAh
charge process on a 1200mAh battery to 1300mAh, for example,
CUT OFF
can protect against extreme overcharging. Consult your battery
manufacturer's recommendation for capacity limits.
The X1 Touch has an integrated safety timer for all charge process-
OFF
es. You can set the maximum charge time as a backup in the event
SAFETY
1-720 Minutes
the X1 Touch is unable to detect the proper charge cut off condi-
TIME
tions. This can happen when charging faulty cells, exhausted packs,
or packs exhibiting abnormal resistance or voltage fluctuations.
If you are using the optional external Temperature Sensor, you can
TEMP
20 C/68 F -
set the temperature cut off. If you are not using the Temperature
CUTOFF
80 C/176 F
Sensor, leave this setting as is.
You can touch
and
ON or OFF. To change the parameters, use the ◄- and +► keys.
The TEMP CUT OFF function can not be OFF. You must use the optional
temperature cable for this function to operate.
SAFETY PROTECTION
DESCRIPTION
on the screen to turn these functions
15
Advertisement
Table of Contents
