Table of Contents
Advertisement
POWER SUPPLY CONNECTIONS
The X1 Touch can be powered either from a wall outlet supplying 100-
240VAC (50-60Hz) using the included AC power cord, or from a 12VDC
automotive battery or an 11 ~ 18 volt DC, 30 amp power supply. If using an
automotive-type battery, make sure it is fully charged before using the X1
Touch. A fully charged 12VDC automotive battery should have a nominal
voltage of about 13.8V.
Using the supplied 4mm bullet
connectors and ePower 30A power
supply.
Using alligator terminal clips
attached to a car battery.
12
Using an AC power cord.
MAIN MENU
When you power up the charger, you will see the following screen. This is
the Main Menu (HOME) screen of the X1 Touch charger.
1. Indicates the current battery settings including: Battery Type /
Number of Cells / Charge and Discharge current and if applicable, Preset Number.
2. BATT TYPE - Battery Type Selection Buttons (choose from LiPo, LiIon, LiFe, NiMh, NiCd
and Pb).
3. OPERATION - Operation-Type Selection Buttons (Operation selections are dependent
on the type of battery selected).
4. CELLS - Press to enter the Cell Count Selection Screen.
5. CAPACITY - Press to enter the Battery Capacity & Charge/Discharge Current selection
screen.
6. SETTING - Press to enter the Settings Menu to set System Settings, Safety Protection
and Charger Parameter Settings.
7. PRESET - Press to go to the Preset Screen, 5 diff erent charge/discharge profi les are
stored here.
8. START - Start button, press to begin the operation indicated on the operation menu.
PROGRAMING INTERFACE
Current Battery Setup
1. Battery Type: LiPo/Lilon/LiFe/NiMH/
NiCd/Pb
2. Battery Cell Count
3. Charging Current (0.1-7.0A)
4. Discharging Current (0.1-2.0A)
5. Preset Number (P1-P5)
13
Advertisement
Table of Contents
