Wireless Programming - Chamberlain Merlin MJ3800R Installation And Operating Instructions Manual

WIRELESS PROGRAMMING

Your door opener has already been programmed at the factory to operate with your hand-held transmitter. The door will
open and close when you press the large centre button.
Below are instructions for programming your opener to operate with additional Security
TO ADD OR REPROGRAM A HAND-HELD TRANSMITTER
USING THE "LEARN" BUTTON
1. Press and hold button on the
transmitter you wish to program to
the opener.
2. The orange LED (indicator light) will
flash to indicate it is receiving signal
from the transmitter.
3. Press & release the orange "learn"
button on the opener. Release the
button on the transmitter. The code
has been learnt.
WIRELESS PROGRAMMING A FINGERPRINT
ENTRY SYSTEM C379 (OPTIONAL) (NOT
SUPPLIED)
Full instructions are available with this accessory.
Once you have enrolled your users into the C379 you can
program the unit into your opener.
Using the orange "LEARN" button:
1. Press and release the orange "learn" button (1) on
opener. The learn indicator light will glow steadily for 30
seconds.
2. Within 30 seconds slide the cover of the C379 up as
illustrated (A). Swipe your finger on the reader head at a
steady speed (B) until the LED turns on (C).
3. When the LED indicator light turns off it has learnt the
code. Ensure there are no obstructions in the path of the
door, then press the send button (D) to test the door.
Note: All previous codes are now erased.
Reprogram each transmitter or keyless entry you wish to
use.
1
If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any 3-button transmitter or mini-transmitter
can be programmed to operate other Merlin Professional
garage door openers or gate openers.
2
3
3
1
18
+ transmitters.
TO ERASE ALL CODES
OPENER MEMORY
To deactivate any unwanted
transmitter, first erase all codes:
Press and hold the orange learn
button on opener until the learn
indicator LED goes out
(approximately 6-9 seconds).
3-BUTTON TRANSMITTERS
C943
C945
Press orange LEARN Button
LED will start flashing
A
Slide the cover plate
ENROLL
up (A)
SEND ENROLL
PASS FAIL
READY RETRY
B
Swipe finger at a
steady speed (B)
C
Yellow LED will indicate
ENROLL
successful swipe (C)
SEND ENROLL
PASS FAIL
READY RETRY
LED indicator light will
turn off
D
Test reader by pressing
the send button (D)
FROM