Alarm Server - EverFocus ECOR960 4F2 User Manual

6.7.5

Alarm Server

You can send out the alarm notifications to EverFocus's CMS software. Please also consult the
CMS's user manual for network alarm settings.
Server IP1~3: IP address of client PC. The network alarm can be transmitted to up to 3
addresses.
Protocol: Select the protocol type for alarm transmission. Note the protocol selected here
should match the protocol set up for the CMS alarm server.
UDP: User Datagram Protocol.
TCP: Transmission Control Protocol.
Port: Select the transmission port for network alarm messages. The port setup here should
match the port set up for the CMS alarm server.
Network ID: The network ID is an identifier for the alarm transmitter (DVR sending the
alarm).
Figure 6-28
91
ECOR960 4F2 / 8F2 / 16F2