Table of Contents
Advertisement
32
Infra Red (IR) Function
Onboard Parallel Port
Onboard Printer Mode
ECP Mode DMA Select
IR Transfer Mode
Disabled: Disabled the IR function.
HKSIR:
Use UART in HKSIR mode
when your IR equipment
meets this specification.
ASKIR:
Use UART in ASKIR mode
when your IR equipment
meets this specification.
Choose the printer I/O address:
378H/IRQ7 (default), 3BCH/IRQ7,
278H/IRQ5
Choose ECP + EPP (default), SPP or EPP,
ECP mode. The mode depends on your
external device that connects to this port.
Choose DMA3 (default) or DMA1. This
setting only works when the Onboard
Printer Mode is set at the ECP mode.
Half-Dup: Use IR function in half-
duplex mode.
Full-Dup: Use IR function in full-duplex
mode.
BIOS Setup
Advertisement
Table of Contents
