Volume Limit / Setting The Maximum Volume Of All Sounds - Minelab GPX 5000 Instruction Manual

Volume Limit
52
Setting the maximum volume of all sounds.
GPX 5000 Range
GPX 4800 Range
Factory Preset
1–20
1–20
12
Volume Limit sets the maximum level of sound emitted by the
detector when a target is detected.
If the Volume Limit is set to maximum all target signals will
be heard, and will sound proportional to the target size and
depth. Maximum limit allows you to hear the difference
between a small and large target, but may be uncomfortable
to your hearing if a large target is found close to the coil.
If the Volume Limit is set to half-way the target signal is
unaffected for a small target but limited for a very large target.
If the Volume Limit is set to minimum most target signals
will potentially be very limited. A low volume will be more
comfortable on your hearing but will increase the risk of
missing small target signals.
Try using a large and small target to adjust the Volume Limit to
a comfortable level.
Note: The Threshold may need to be reset if adjusting the
Volume Limit to a low setting.
Caution: The detector is able to produce an extremely high
volume if a large or shallow target is located.
Protect your ears!
The Volume Limit may need to be re-adjusted when
switching between headphones and an external speaker.