CYBEX 525T Owner's Manual page 20

4. Thread six bolts into the remaining holes of the right upright and left upright.
1
2
5. Tighten all of the bolts using a 7/32" Allen wrench and 9/16" open end wrench.
Connect the Display Cable
The display cable and CSAFE cable have the same connectors. The display cable is black, the
CSAFE cable is red.
1. Route the cables under all other cables and towards the base plate.
2. Plug the display cable, located at the bottom of the upright assembly into the communication
port of the controller.
1
4
5
Cybex Owner's Manual
3
3
2
Item Description
1 2 Console
2
4 Upright (Right shown)
3 15 Bolt
Item Description
1 Controller
2 Communication port
3
Display cable, Black
4 CSAFE cable, Red (optional)
5 Coax cable (optional)
20