Network Setup; For A Wired Connection; For A Wireless Connection - Topfield TRF-7260 User Reference

44 Accessing via Network

8.2 Network setup

8.2.1 For a wired connection

8.2.2 For a wireless connection

inform the DDNS service provider of the new IP address. This makes
it possible that you access the router with a domain name at any time.
1. Connect your Ethernet cable from your router to the Topfield
recorder.
2. Press Installation > Network Setting > IP Setting.
3. It is recommended to use a dynamic IP address by the router
therefore select DHCP as the connection type. However if a
static connection is set then please refer to your router for an
IP address, Subnet Mask, Gateway, Primary DNS, Secondary
DNS.
4. Scroll down to activate profile and press the OK button on the
remote.
5. A successful connection will populate all the IP settings and the
Level/Quality bars on the TV screen will show a high percent-
age level.
1. Connect the USB wireless dongle to the USB port on the PVR.
2. Press Installation > Network Setting > IP Setting.
3. Select Wired/Wireless LAN. Then select Wireless as the pre-
ferred connection.
5. Select AP list and press OK. A list of available networks will be
shown, then select your personal network.
6. Once network is selected choose the security mode
WPA / WPA2 / WEP. Select your WPA / WPA2 / WEP al-
gorithm according to your router setting.
7. Entre the pre-shared key which is also known as your network
password. Network password must be exactly the same as your
router setting including Upper/Lower case and any numbers
used.
8. A successful connection will populate all the IP settings and the
Level/Quality bars on the TV screen will show a high percent-
age level. If the fields are not populated check the password and
any security settings.