Installation (In-Dash Mounting) - JVC GET0266-003A Instruction Manual

KD-G617
Installation/Connection Manual
GET0270-002A
[EE]
ENGLISH
This receiver is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If
your vehicle does not have this system, a voltage inverter is required, which can be purchased
at JVC IN-CAR ENTERTAINMENT dealers.
Parts list for installation and connection
The following parts are provided for this receiver.
After checking them, please set them correctly.
A / B
Hard case/Control panel
E
Power cord
I
Rubber cushion

INSTALLATION (IN-DASH MOUNTING)

The following illustration shows a typical installation. If you have any questions or require
information regarding installation kits, consult your JVC IN-CAR ENTERTAINMENT dealer or a
company supplying kits.
• If you are not sure how to install this receiver correctly, have it installed by a qualified
technician.
Removing the receiver
Before removing the receiver, release the rear section.
C
Sleeve
F
Washer (ø5)
J
Handles
* 1 When you stand the
receiver, be careful not to
damage the fuse on the
rear.
1
*
G
Lock nut (M5)
K
Remote controller
•
Do the required electrical connections.
Insert the two handles, then pull them
as illustrated so that the receiver can be
removed.
1
0105DTSMDTJEIN
EN, RU
D
Trim plate
H
Mounting bolt (M5 x 20 mm)
L
Battery
Bend the appropriate tabs to hold the
sleeve firmly in place.