JVC GET0266-003A Instruction Manual page 83

ENGLISH
A
Typical Connections / Типичные подключения
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause
serious damage to this receiver.
The leads of the power cord and those of the connector from the car body may be different in
color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the aerial cord.
3
Finally connect the wiring harness to the receiver.
Note: If your vehicle does not have any accessory terminal, move the fuse from the fuse
position 1 (initial position) to fuse position 2, and connect the red lead (A7) to the positive (+)
battery terminal.
• The yellow lead (A4) is not used in this case.
Rear ground terminal
Aerial terminal
Line out (see diagram
2
* Before checking the operation of this
receiver prior to installation, this lead must
be connected, otherwise power cannot be
turned on.
* 2
White with black stripe White
Left speaker (front)
SUBWOOFER (see diagram
To CD changer/DAB tuner or another external component
(see diagram )
15 A fuse
Black
)
2
*
Yellow
2
*
Red
Blue with white stripe
Orange with white stripe
Brown
Gray with black stripe Gray
Right speaker (front)
Перед началом подключений:
1
2
3
Примечание:
•
)
* 1
Not included for this receiver
* 1
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
To an accessory terminal in the fuse block
To the remote lead of other equipment or power aerial if any
(200 mA max.)
Green with black stripe Green
Left speaker (rear)
3
Fuse position 2 /
Fuse position 1 /
Ignition switch
Fuse block
To car light control switch
To cellular phone system
Purple with black stripe Purple
Right speaker (rear)