KVH Industries TracVision R5SL Installation And Operation Instructions Manual page 3

Upgrading New TracVision Systems
If you are installing the Tri-Sat AutoSwitch Kit as
part of a new TracVision system installation, note
the following variations to the TracVision
Installation Guide.
• Only wire the receivers as specified in
these instructions
• Do not mount the switchplate until
you have finished installing the Tri-
Sat AutoSwitch Kit.
• Be sure to also wire the switchplate as
specified in the TracVision
Installation Guide.
Step 2 - Connect the Tri-Sat AutoSwitch Kit
This section explains how to connect the Tri-Sat
AutoSwitch Kit and a DIRECTV H21-200 or H20-
600 receiver.
NOTE: For information on wiring additional
components, refer to the Appendix on page 9.
a. Systems with a grounding block - Connect
the RF1 cable (A) from the grounding block's
RF1 connection to the "From Antenna"
connector on the Tri-Sat AutoSwitch (see
Figure 3).
Systems without a grounding block -
Connect the antenna's RF1 cable (A) to the
"From Antenna" connector on the Tri-Sat
AutoSwitch (see Figure 3).
Figure 3 Tri-Sat AutoSwitch Wiring Diagram
Antenna
RF2 RF1
Grounding
Block
(A)
TracVision Switchplate
Standard
Previously Installed
Receiver
TracVision Systems
(optional)
DB9 Connector on
Front of Switchplate
New TracVision Systems
RJ22 Connector on
Back of Switchplate
From Antenna
To DIRECTV HD
Receiver Coax
Control Output
(C)
Satellite In
COMPONENT OUT
OFF-AIR IN SATELLITE IN
CAUTION
S-VIDEO OUT
USB
Vehicle
AC Ground
To DIRECTV HD
Receiver USB
(D)
(B)
USB
AC 120V, 60 Hz
DIGITAL AUDIO
OUT OPTICAL RF REMOTE
PHONE JACK
ANTENNA
AUDIO OUT HDMI OUT
3