Canon CLC3220 Network Manual page 73

24
Restart the machine.
❑
Turn OFF the machine, wait at least 10 seconds, and then turn it ON again.
NOTE
For instructions on how to turn ON/OFF the machine, see Chapter 1, "Before You Start Using
This Machine," in the Reference Guide.
25
Check to see if the network settings you specified are set correctly.
❑
➞ [System Settings] ➞ [Network Settings] ➞ [TCP/IP Settings].
Press
❑
Press [PING Command].
❑
Enter an IP address that exists on the network ➞ press [Start].
Use - (numeric keys) to enter an IP address.
When you press [Start], the result of the PING command appears on the touch panel
display.
If this result is inappropriate, check the settings described in "Interface Settings," on p. 2-9,
and "TCP/IP Settings," on p. 3-4.
3-23
Protocol Settings
3