Basic Recording - JVC YU30052-625-1 Instructions Manual

20
EN

Basic Recording

You should already have performed the necessary preparations (
"AUTO" and try recording that way before attempting to use more advanced features.
POWER LAMP
OFF
5S
RECORD/STANDBY
NOTE:
Before starting recording, make sure you set the date and time (
recording, they are recorded onto the tape and can be displayed during playback (
1 PULL OUT VIEWFINDER
Align its mark with "STANDBY".
2 TURN ON POWER
Set the Power Dial to "REC". The power lamp
comes on and RECORD/STANDBY mode is
engaged.
•If you don't pull out the viewfinder, the
power cannot be turned on.
3 SELECT OPERATION MODE
Set the Select Dial to "AUTO".
•In the "AUTO" mode, only Zoom (20x),
Snapshot, 5S (if you change the setting in the
System Menu, either 5SD or ANIMATION
becomes available – see pgs. 18 – 19) and
Self-Timer are available.
4
START RECORDING
When "PAUSE" appears in the viewfinder,
press RECORDING START/STOP. A beep
signals the start of recording.
VIEWFINDER
PAUSE
pgs. 8 – 19). Set the Select Dial to
STANDBY
RECORDING
START/STOP
BUTTON
pg. 11). Even if they don't appear during
5
END RECORDING
When you're finished recording, press
RECORDING START/STOP. Align the
viewfinder's mark with "CAMERA OFF"; the
power lamp goes out and the lens cover closes
automatically.
• When transporting, make sure the viewfinder is in
this position.
• Before turning the power on again, you must pull
out the viewfinder.
NOTES:
If 5 minutes elapse in the RECORD/STANDBY mode, the
power shuts off automatically to conserve energy. To turn
the camcorder on again, set the Power Dial to "OFF",
then to "REC". As long as you don't take out the tape you
were using or play it back, you can continue recording
from where you left off with no noticeable break.
RECORD/STANDBY means that a tape is loaded and the
camcorder is ready to record.
If RECORD/STANDBY (Pause) is engaged for 5 minutes,
the Stop mode is automatically activated to protect the
heads.
If you start a recording on a blank portion of the tape, or
onto a brand new tape, recording starts approximately
3-4 seconds after you press RECORDING START/STOP.
In order to record the entire scene or sequence, make
sure to start recording slightly in advance
RECORDING
VIEWFINDER
OFF
5S
DURING
RECORDING
AUTO
FOCUS
EXP.
SET
pg. 45).
.
(Cont.)
REC
WB
PRO