Programming Wireless Keypad - Polaris 700 Installation Manual

Programming a Wireless Keypad To A Receiver
1. Refer to the DIP switch settings on your handheld remote and take
notes on the chart below which switches are in the "On" or "Closed"
positions. You must have at least 1 of the 10 switches closed.
2. Press the Radio Learn button twice. The light at the top of the Key-
pad will illuminate and stay lit.
3. Press the numbers that respresent the closed switches on the
remote slowly and firmly (i.e. if switches 2,4, and 6 are closed, enter
246. For switch position 10, use the 0 key. "
4. Press the Radio Learn button once.
5. To test if you have properly programmed in the Radio Code, enter
the factory set PIN (1-2-3-4). The Gate should activate.
Digital Type Switches
If the flat side or the side you push down is toward
the number, then the switch is on.
Write the "ON" numbers of your RADIO CODE in the boxes shown
below at this time. A "RADIO CODE" with ALL positions open
(OFF) or ALL jumper wires clipped can NOT be used.
Please refer to instructions provided with the wireless keypad for programming of
master and secondary pin numbers.
42