Polaris 700 Installation Manual page 19

WIRING OPERATOR
Figure 21
Battery
Step 5
Connect the battery terminal wires
to the battery.
Step 6
Plug in transformer. Turn control
box power switch to the ON
position.
Second battery (not included)
Black (-) terminal wire
Red (+) terminal wire
19
Step 3
The transformer provided is for dry location use only. If used
in an outside outlet, the transformer must be enclosed or
covered for weather protection. Attach AC power wire to the
transformer.
NOTE: DO NOT PLUG TRANSFORMER INTO AC POWER
UNTIL ALL WIRING IS COMPLETED.
Step 4
Install the battery by placing the battery into the control
box. The control box can accommodate one or two batteries.
Warning:
Do not attempt to splice operator wires for
the purpose of extending your wiring connections. Doing
so can void your warranty. Contact technical support for
recommended procedure. 1-800-234-3952.
Figure 22