Epson EB-1430Wi Installation Manual page 36

Installation Guide
b
Loosen the M4 bolts (x2) and extend the arm slide on the setting plate
Align the slider with the combined distances of (b) and (x) that you checked in step 1.
c
Route the necessary cables through the setting plate
See the following figure to route the cables so that the ends of the cables that connect to the projector
are on the projector's interface side.
Warning
Do not hang the rest of the cable over the setting plate. They could fall and cause an accident.
c
•
Route the cables connected to the Control Pad through the setting plate.
•
Route the cables connected to the Touch Unit through the setting plate (EB-1430Wi only). Route
the cable so that the end that connects to the Touch Unit appears from the lower part of the
setting plate.
35