Grip Adjustment; Tripod Mounting; Inserting/Removing An Sd Card - JVC GZ-MG70E Instructions Manual

M5E6PAL.book Page 19 Friday, August 26, 2005 8:16 PM

Grip Adjustment

1
Adjust the velcro strip.
2
Pass your right hand
through the loop and grasp
the grip.
3
Adjust your thumb and
fingers to easily operate
the recording start/stop
button, power switch and
zoom lever. Be sure to
fasten the velcro strip to
your preference.

Tripod Mounting

To attach the camera to a
tripod, align the direction
stud and screw to the
mounting socket and
stud hole on the camera.
Then tighten the screw
clockwise.
Some tripods are not
equipped with studs.
MasterPage: Start_Right
GETTING STARTED

Inserting/Removing an SD Card

You can use an SD card as a recording medium
in the SD slot. See page 62 for the guaranteed
media to work with this camera.
Clipped Edge
SD Card (optional)
Label
SD Card Cover [OPEN]
SD Slot
1
Make sure the camera's power is off.
2
Open the SD card cover.
3
To insert an SD card, firmly insert it with its
clipped edge first.
To remove an SD card, push it once. After the
SD card comes out of the camera, pull it out.
Do not touch the terminal on the reverse side of
the label.
4
Close the SD card cover.
To protect valuable files
Slide the write/erase protection tab on the side
of the SD card in the direction of "LOCK". This
prevents the SD card from being recorded over.
To record on this SD card, slide the tab back to
the position opposite to "LOCK" before inserting
it.
NOTE:
Before using a new SD card, it is necessary to
format the card. ( pg. 20)
ATTENTION:
Do not insert or remove the SD card while the
camera is turned on, as this may cause the data on
the SD card to be corrupted or cause the camera to
become unable to recognise whether or not the SD
card is installed.
19
EN
Write/Erase
Protection Tab