900Ub Upright Assembly Drawing - Diamondback 900Ub Upright User Information

900Ub Upright Assembly Drawing

6
900Ub Upright Assembly Instructions
Step 1: Stabilizer Bars Assembly
1. Place rear stabilizer bar under rear main frame body and align screw
holes.
2. Insert two M8 x 90mm bolts into the stabilizer bar all the way through
and into the holes on the frame
3. Secure rear stabilizer bar using an M8 nut and a curved washer on
each bolt.
4. Repeat steps 1 – 3 to attach front stabilizer bar.
Step 2: Pedal Assembly
1. Use a 15mm open-end wrench to fi rmly affi x the pedals to the cranks.
2. The left and right pedals are different and are denoted as right or left (R
or L) on the top & bottom of each pedal.
NOTE: Left pedal threads counterclockwise.
3. Retighten cranks after approximately 10 hours of use.
Step 3: Seat Post and Saddle assembly
1. Loosen the seat pin by turning it counter-clockwise 1-2 turns. Install seatpost
by sliding it into seatpost receptor, pulling the seat pin out until a suitable hole is
found.
2. Assemble saddle onto seatpost.
3. Tighten the affi xing nut and washer using a 17mm open-end wrench.
SADDLE ANGLE ADJUSTMENT HINT: Hold the rear of saddle in the optimum
comfort position and tighten the nut at the same time
Step 4: Console Mast Assembly
1. Remove the console mast plastic cover from the unit's body
by un-smapping it.
2. Install console mast cover onto console mast.
3. Connect the main wire harness in the main frame to the
main wire harness in the bottom of the console mast, taking
care to install correctly. (See plug alignment marks)
4. Install the console mast by sliding it into the console mast
receptor while gently pulling the wiring harness. This will
keep the slack out of the harness so the wires will not get
pinched and short out. Insert and tighten three M8 x 16mm
bolts, one fl at washer on each side and a curve washer on
the front using a 6mm Allen wrench. Be sure not to pinch
wire harness while tightening these three screws and make
sure that the two top holes are lined up with the holes on
the receptor.
7