Alfa Romeo 33 Workshop Manual page 79

3. Reassembty of electrical tables
Lower the auto lift and, with reference
11.
For fol!owing procedhes steps, refer
'Refit hose ~@ to;clutch pump and ful-
Mind that centr&nuts ontwo sides of
the manifold~ serve also to fix brackets
6. Completio'n of reassembly
a. Reconnect injectionlignition wiring
in reverse 'order to that described un-
c. Reconnect hoses '@ a n d 8 re-
spectively to damper Q and pressu-
re gauge
d. Reconnect pipelines of engine coo-
ling system pin reverse ordxer to that
described under "Removal"' - Step 5.
e. Reconnect fuel vapour and air in pi-
pelines in 'reverse order to that descri-
bed under "Removal" - Step 4.
'butor cap ~ 0 .
g . Reinstall air filter caver 0
flow sensor i ' 0
and corrugated slee-
in reverse order to that descri-
bed under "Removal': - Step 2.
ENGINE MAIN MECHANICAL IdIT
h. Remount hood.
i. Remount the battery negative termi-
nal.
rubber gaiters on the gear lever.
1.7 IE without catalytic,converter
is necessary to remove engine and
gearbox-differential unit as a single
unit. Put the vehicle on the auto lift
and engage first gear.
WARNING:
Great tare is required when operating
on a hot engine.
1. Preliminary operations
Operate as described at Step 1 page
o-2
For the following procedure steps re,
fer to Figure at page 01-9.
2. Air filter, air flow sensor and sleeve
Operate as described at Step 2 page
01-2.
3. Removal of spark plugs supply ca-
bles
Operate as described at Step 3 page
, air
4. Removal of air pipes
Disengage the following pipes, di-
sconnecting them from stated compo-
nents:
Pipe @ from supply manifold @ .
l
Pipe @ , from throttle body and pi-
l
pe 0 fro,m pneumatic gauge on
ignition distributor 0.
Pipe @ , from idle RPM setting fit-
l
t i n g .
Pipe 8 , from supply manifold @
l
Pipe 0 unscrewing fitting,on syp-
l
ply manifold @
5. Removal of cooling circuit pipes
Operate as described at Step 5 page
6. Removal of fuel supply hose
Operate as described at Step 6 page
7. Removal, of accelerator control ca-
ble
Operate as described at Step 7 page
8. Removal of: ignitionlinjection tables
a. Unscrew two screws and remove so-
lenoid starters @ from body.
b . D i s c o n n e c t connection @ bet-
ween ignitionlinjection wiring and ve-
c. Disconnect connecter @ from
throttle body'switch @ .
9. IRemoval of supply manifold
Operate as described at Step 9 page
01-2.
10. Removal of clutch control hose
Operate as described at Step 10 page
01-2.
PA32 790088330 1