Table of Contents
Advertisement
1 Fuel vapour intake tube
2 Vacuum pressure tube for dump valve
control
3 External air delivery tube
4 Fuel tank
5 Fuel vapour breather; hose
battery latiles are not properly
T
O
rapid baftery charger.
engine is started.
In no case use a rapid battery
10 Fuel !vapour filter
When painting in furnace at tem-
perature over 80 OC, remove the
electronic control unit.
Make sure that screened wire
connections are properly connec-
ted.
ignition is switched on.
7 Fuel :iapour separator
low voltage tables, for testing.
Should any accessories be moun-
.
ted on vehicle, it is always advisa-
ble to disconnect electonic CU
and to check the functioning ac-
cessories with the CU disconnec-
ver to connect any leads (other
than those of the CU itself),to the
wiring of the CU.
- Quick Links:
- Engine Maintenance
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
