Instrumentation and Controls
•
On Velvet Drive models, the shift lever must be in the designated detent position for
each gear.
Velvet Drive 5000 series (8 degree down angle shown, V-drive similar)
•
On ZF Marine (Hurth) transmissions, the shift lever must be against the stops for
forward and reverse, and in the centered detent position for neutral.
Page 9A-18
e
b
a -
Transmission shift lever
b -
Poppet ball must be centered in
this detent hole when left-hand
propeller shaft rotation is desired
c -
Poppet ball must be centered in
this detent hole when right-hand
propeller shaft rotation is desired
b
Typical ZF Marine (Hurth) transmission shown
a -
Shift lever
a
c
d
7665
d -
Poppet ball must be centered in this
detent hole for neutral position
e -
Install shift lever stud in this hole
when using quicksilver shift cables
a
8297
b -
Shift cable bracket
90-863758060 AUGUST 2006