Using External Components; Connecting The Video Signal Cables; Connecting The Ieee1394 Cable; Composite And Component Connections - JVC GY- HD101 Instruction Manual

USING EXTERNAL COMPONENTS

Connecting the Video Signal Cables

Clamp filter
Wind once
Composite cable
Component cable
C H A N G E 1 3 9 4 S W I T C H
54
IEEE1394 switch
IEEE 1394
HDV
DV
IEEE 1394
HDV
DV

Connecting the IEEE1394 Cable

To reduce the emission of unwanted radio waves, be sure to
attach the provided clamp filter as shown in the figure on the
left.
• Attach the clamp filter as close to the camcorder as possi-
ble, as shown in the figure.
• Set the IEEE1394 switch on the left panel of the cam-
corder.
DV : DV format
HDV : HDV format
CAUTION
Connect the cables and set the switches with the power on
the device OFF.

Composite and Component Connections

The video signals output from the video signal output connec-
tors on this camcorder (VIDEO/Y, P
below, depending on the settings for the OUTPUT TERMI-
NAL item on the VIDEO FORMAT menu screen.
AUTO : Automatically switches to a composite or
component signal, depending on which
cable is connected to the video signal
output terminal and outputs the signal.
COMPOSITE : Outputs a composite signal regardless of
which cable is connected to the video sig-
nal output connector.
COMPONENT : Outputs a component signal regardless
of which cable is connected to the video
signal output connector.
Output signal when AUTO is set
Connector (G: Unconnected F: Connected)
VIDEO/Y P
B
F F
F G
F F
F G
None of the above
In addition, you can use the PB TAPE item to set whether to
automatically detect the video format of the playback tape or
only play back a particular format when playing back a tape.
X See page 63.
CAUTION
Be careful not to apply excess force to the video signal out-
put terminal when connecting or disconnecting the cable.
This will cause poor contact or failure.
Displaying Alarms
• CHANGE 1394 SWITCH
Displayed when the setting for the input/output video format
from the IEEE1394 connector and the setting for the
IEEE1394 switch are different.
Set the IEEE1394 switch so it matches the video format.
, P ) are as described
B R
Output
Signal
P
R
COMPONENT
F
COMPOSITE
F
COMPONENT
G
COMPOSITE
G
OFF