Formatted Capacity; Lba Mode - Seagate ST3000VX000 Product Manual

www.seagate.com
Table 1 Drive specifications summary for 3TB, 2TB and 1TB models (Continued)
Drive Specification
Altitude, non-operating
(below mean sea level, max)
Operational Shock (max)
Non-Operational Shock (max)
Vibration, operating
Vibration, non-operating
Drive acoustics, sound power
Idle**
Seek
Non-recoverable read errors
Annualized Failure Rate (AFR)
Warranty
Load/Unload cycles
(25°C, 50% rel. humidity)
Supports Hotplug operation per the
Serial ATA Revision 3.2 specification
*One GB equals one billion bytes and 1TB equals one trillion bytes when referring to hard drive capacity. Accessible capacity may vary depending
on operating environment and formatting.
* *During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels.
*** All specifications above are based on native configurations.
2.2

Formatted capacity

Model
ST3000VX000
ST2000VX000
ST1000VX000
*One GB equals one billion bytes and 1TB equals one trillion bytes when referring to hard drive capacity. Accessible capacity may vary depending
on operating environment and formatting.
2.2.1

LBA mode

When addressing these drives in LBA mode, all blocks (sectors) are consecutively numbered from 0 to n–1, where
n is the number of guaranteed sectors as defined above.
See Section 4.3.1, "Identify Device command" (words 60-61 and 100-103) for additional information about 48-bit
addressing support of drives with capacities over 137GB.
Seagate SV35 Series HDD Product Manual, Rev. E
ST3000VX000
–304.8m to 12,192m
(–1000 ft to 40,000+ ft)
80 Gs at 2ms
300 Gs at 2ms
2Hz to 22Hz: 0.25 Gs
(Limited displacement)
22Hz to 350Hz: 0.50 Gs
350Hz to 500Hz: 0.25 Gs
5Hz to 22Hz: 3.0 Gs
22Hz to 350Hz: 3.0 Gs
350Hz to 500Hz: 3.0 Gs
2.4 bels (typical)
2.6 bels (max)
2.6 bels (typical)
2.7 bels (max)
14
1 per 10 bits read
<1%
To determine the warranty for a specific drive, use a web browser to access the following web page:
http://www.seagate.com/support/warranty-and-replacements/.
From this page, click on the "Check to see if the drive is under Warranty" link. The following are required to be
provided: the drive serial number, model number (or part number) and country of purchase. The system will
display the warranty information for the drive.
300,000
Yes
Formatted
capacity*
3000GB
2000GB
1000GB
ST2000VX000
–304.8m to 12,192m
(–1000 ft to 40,000+ ft)
80 Gs at 2ms
300 Gs at 2ms
2Hz to 22Hz: 0.25 Gs
(Limited displacement)
22Hz to 350Hz: 0.50 Gs
350Hz to 500Hz: 0.25 Gs
5Hz to 22Hz: 3.0 Gs
22Hz to 350Hz: 3.0 Gs
350Hz to 500Hz: 3.0 Gs
2.4 bels (typical)
2.6 bels (max)
2.6 bels (typical)
2.7 bels (max)
14
1 per 10 bits read
<1%
300,000
Yes
Guaranteed
sectors
5,860,533,168
3,907,029,168
1,953,525,168
ST1000VX000
–304.8m to 12,192m
(–1000 ft to 40,000+ ft)
80 Gs at 2ms
350 Gs at 2ms
2Hz to 22Hz: 0.25 Gs
(Limited displacement)
22Hz to 350Hz: 0.50 Gs
350Hz to 500Hz: 0.25 Gs
5Hz to 22Hz: 3.0 Gs
22Hz to 350Hz: 3.0 Gs
350Hz to 500Hz: 3.0 Gs
2.2 bels (typical)
2.3 bels (max)
2.3 bels (typical)
2.4 bels (max)
14
1 per 10 bits read
<1%
300,000
Yes
Bytes per sector
4K
5