Page 1
Product Manual Seagate SV35 Series ® ST3000VX000 ST2000VX000 ST1000VX000 100687219 Rev. E May 2014...
Page 2
Seagate, Seagate Technology and the Wave logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. SV35 and SeaTools are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries. All other trademarks or registered trademarks are the property of their respective owners.
Authorized Service Centers For information regarding Warranty Support, visit: http://www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit http://www.seagate.com/services-software/data-recovery-services/ For Seagate OEM and Distribution partner portal, visit: http://www.seagate.com/partners/ For Seagate reseller portal, visit: http://www.seagate.com/partners/my-spp-dashboard/ Seagate SV35 Series HDD Product Manual, Rev. E...
• Seagate AcuTrac™ servo technology delivers dependable performance, even with hard drive track widths of only 75 nanometers. • Seagate OptiCache™ technology boosts overall performance by as much as 45% over the previous generation. • Quiet operation • Compliant with RoHS requirements in China and Europe •...
Shadow Register Block. All SATA devices behave like Device 0 devices. For additional information about how SATA emulates parallel ATA, refer to the “Serial ATA International Organization: Serial ATA Revision 3.2.” The specification can be downloaded from www.sata-io.org. Seagate SV35 Series HDD Product Manual, Rev. E...
40.0°C max (non-operating) 40.0°C (non-operating) 40.0°C max (non-operating) Altitude, operating –304.8m to 3048m –304.8m to 3048m –304.8m to 3048m (–1000 ft to 10,000+ ft) (–1000 ft to 10,000+ ft) (–1000 ft to 10,000+ ft) Seagate SV35 Series HDD Product Manual, Rev. E...
See Section 4.3.1, "Identify Device command" (words 60-61 and 100-103) for additional information about 48-bit addressing support of drives with capacities over 137GB. Seagate SV35 Series HDD Product Manual, Rev. E...
10 (typical) 10 (typical) 10 (typical) (in seconds) 11 (max) 11 (max) 11 (max) Time-to-ready may be longer than normal if the drive power is removed without going through normal OS powerdown procedures. Seagate SV35 Series HDD Product Manual, Rev. E...
0.006 Sleep 0.63 0.111 0.006 * During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. †DIPLM Enabled Seagate SV35 Series HDD Product Manual, Rev. E...
Standby mode. In both Idle and Standby mode, the drive accepts all commands and returns to Active mode when disk access is necessary. Seagate SV35 Series HDD Product Manual, Rev. E...
These drives comply with the performance levels specified in this document when subjected to a maximum operating shock of 80 Gs based on half-sine shock pulses of 2 ms during read operations. Shocks should not be repeated more than two times per second. Seagate SV35 Series HDD Product Manual, Rev. E...
Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses this threshold curve (originated in ISO 389-7) to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards.
2.13 Agency certification 2.13.1 Safety certification These products are certified to meet the requirements of UL60950-1, CSA60950-1 and EN60950 and so marked as to the certify agency. Seagate SV35 Series HDD Product Manual, Rev. E...
As a subassembly, no Federal Communications Commission verification or certification of the device is required. Seagate has tested this device in enclosures as described above to ensure that the total assembly (enclosure, disk drive, motherboard, power supply, etc.) does comply with the limits for a Class B computing device, pursuant to Subpart J, Part 15 of the FCC rules.
The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging. In addition, electronic components should never be exposed to condensing water on the surface of the printed circuit board assembly (PCBA) or exposed to an ambient relative humidity greater than 95%.
For installations which require cables, users can connect the drive as illustrated in Figure 1 Figure 1 Attaching SATA cabling Signal connector Power connector Signal cable Power cable Each cable is keyed to ensure correct orientation. SV35 Series HDD drives support latching SATA connectors. Seagate SV35 Series HDD Product Manual, Rev. E...
2x 0.125 in 3.18 mm 4X 6-32 UNC-2B 3 MINIMUM THREAD DEPTH 0.15 MAXIMUM FASTENER PENETRATION 2x 3.750 in 95.25 mm Note. Image is for reference only, and may not represent actual drive. Seagate SV35 Series HDD Product Manual, Rev. E...
Page 21
2x 0.125 in 3.18 mm 4X 6-32 UNC-2B 3 MINIMUM THREAD DEPTH 0.15 MAXIMUM FASTENER PENETRATION 2x 3.750 in 95.25 mm Note. Image is for reference only, and may not represent actual drive. Seagate SV35 Series HDD Product Manual, Rev. E...
3. There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-mate backplane configuration. • All used voltage pins (V ) must be terminated. Seagate SV35 Series HDD Product Manual, Rev. E...
(40 ASCII characters, padded with blanks to end of string) (Bits 7–0) Maximum sectors per interrupt on Read multiple and Write 8010 multiple (16) Reserved 0000 Standard Standby timer, IORDY supported and may be disabled 2F00 Seagate SV35 Series HDD Product Manual, Rev. E...
Page 26
0028 Command sets supported 364B Command sets supported 7F09 Command sets support extension (see note following this table) 4163 Command sets enabled 30xx Command sets enabled BE09 Command sets enable extension 4163 Seagate SV35 Series HDD Product Manual, Rev. E...
Page 27
Multiword DMA mode 2 is currently active. Word 84 SMART error login is supported. SMART self-test is supported. Media serial number is supported. Media Card Pass Through Command feature set is supported. Streaming feature set is supported. Seagate SV35 Series HDD Product Manual, Rev. E...
Page 28
Ultra DMA mode 2 is currently active. Ultra DMA mode 3 is currently active. Ultra DMA mode 4 is currently active. Ultra DMA mode 5 is currently active. Ultra DMA mode 6 is currently active. Seagate SV35 Series HDD Product Manual, Rev. E...
Disable use of SATA features Enable read look-ahead (read cache) feature (default). Report full capacity available At power-on, or after a hardware or software reset, the Note default values of the features are as indicated above. Seagate SV35 Series HDD Product Manual, Rev. E...
S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the Note command is aborted and 0x 04 (abort) is written to the Error register. Seagate SV35 Series HDD Product Manual, Rev. E...
Page 34
ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888 EUROPE, MIDDLE EAST AND AFRICA Seagate Technology SAS 16-18 rue du Dôme, 92100 Boulogne-Billancourt, France, 33 1-4186 10 00 Publication Number: 100687219, Rev. E...