Monitor Configuration - TANDBERG 8000 MXP User Manual

TANDBERG 8000 MXP User Manual

2.3 Monitor Configuration

Monitor configuration
Power up the system by using the power rail in the bottom of the base. Switch the system on
by activating the power switch on the codec (located on the right hand side at the rear of the
codec). A green light is shown (located in the center on the front of the codec). After the
system has performed a self-test routine, the main menu will be displayed on the monitor.
If the system does not start, check the following:
 Check that the monitors are receiving power by looking at the right hand side. You
should see a red light. The monitor must have power in order to be switched on by
the codec.
 Check that the codec is switched on.
 If there is still no signal on the monitor, press the RGB button on the monitor remote
control in order to select the VGA input on the monitor.
 Press 'SCREEN' on the monitor remote control in order to select which view type is to
be used on the monitor.
 Recommended view is FULL. This is a 16:9 mode that utilizes the full size of the
monitor. Point the remote control towards the lower right of each monitor (where the
IR sensor is located) in order to switch mode. For the second monitor, this must also
be done for the VGA input: Press 'RGB [D-sub]' to select this input, then 'SCREEN'
until the FULL view is shown.
IMPORTANT!
To allow the Plasma Monitors to be switched on/off by the system, they must be set to
Power Save Mode:
 Press MENU on the Plasma Remote Control
 Select SETUP
 Set POWER MANAGEMENT: ON
 Press MENU to remove the menu.
Securing the cables
It is important that the wires are secured inside the base so that they don't get in the way of
the covers, which are to be screwed on to the back.
Attaching the back covers Screw the two back covers on to the base. The lower of the two
covers should be attached first.
18