Summary of Contents for Datalogic QuickScan QS6500BT
Page 1
QuickScan QS6500BT General Purpose Handheld Linear Imager Bar Code Reader with Bluetooth® Wireless Technology Quick Reference Guide...
Page 2
Datalogic website (www.scanning.datalogic.com) or provided on appropriate media. If you visit our website and would like to make comments or suggestions about this or other Datalogic publications, please let us know via the "Contact Datalogic" page. Disclaimer...
Page 3
Product, you will be deemed to have accepted the terms and conditions of this Agreement. If you do not intend to be bound to the terms of this Agreement, Datalogic is not willing to license the Software to you, you may not use the Datalogic Product or the Software, and you must contact the party from whom you acquired the Datalogic Product for instructions.
Page 4
3. Transfers, Support. Any copying, installing, reproduction, remanufacture, reverse engineering, electronic trans- fer, or other use of the Software on other than the designated Datalogic Product will be a material breach of this Agreement. However, Datalogic may elect not to terminate this Agreement or the granted licenses, but instead may elect to notify End User that End User is deemed to have ordered and accepted a license for each breaching use.
Page 5
2) Datalogic controls the defense or settlement of the claim, and 3) End User cooper- ates fully with Datalogic in such defense or settlement. All notices of a claim should be sent to Datalogic Scanning, Inc., Legal Department, 111 SW Fifth Ave. Suite 4100, Portland, OR 97204-3644.
Page 6
End User agrees to sign a waiver prepared by Datalogic concerning further use of the embedded Software. End User’s resumed or continued use of the embedded Software after termination shall constitute End User’s agreement to be bound by the terms and conditions of this Agreement for such use.
Installation The QuickScan QS6500BT linear imager is easy to install and use. The following figures show the steps to perform an installa- tion. Turn off the host computer before connection. Consult the host terminal’s manual if necessary. Base Station Power Cable Routing 1.
Page 10
8. Place the linear imager in the Base Station and verify the charge LED is flashing. After five minutes, the scanner will have sufficient charge to begin reading labels. A full charge from depleted battery will take approximately 2 hours. 9.
Battery Warnings and Cautions Do not discharge the battery using any device except for the linear imager. When the battery is used in devices other than the linear imager, it may damage the battery or reduce its life expectancy. If the device causes an abnormal current to flow, it may cause the battery to become hot, explode or ignite and WARNING cause serious injury.
Page 12
Always charge the battery at 32°–113°F (0°–45°C) tempera- ture range. Use only the authorized power supplies, battery pack, char- gers, and docks supplied by your Datalogic reseller. The use CAUTION of any other power supplies can damage the linear imager and void your warranty.
Power Supply Models require either a Listed class II or class III with a Limited Power Source (LPS). For the safety certification to be valid, class III input power sources must be IEC/EN60950-1 (EN 60335- series, EN 60065 or relevant) approved. Input: 100 - 240 VAC Output: 9 - 12 VDC Max.
How to Scan The figure below shows the right and wrong ways to scan a bar code. 1. The linear imager must be pointed at a slight angle to the bar code so that the light reflected off the bar code can be “seen” by the linear imager.
Troubleshooting If the linear imager is not operating properly, the following checks should be performed: 1. The BT linear imager uses an internal battery and if the bat- tery is fully depleted or failed, the linear imager will not operate. Exchange the battery with a known good unit and retest the linear imager.
If the linear imager still does not function properly, contact your local supplier or Datalogic Customer Support Services. Statement of Compliance This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions: 1.
Page 17
• Connect the equipment into an outlet on a circuit dif- ferent from that to which receiver is connected • Consult the dealer or an experienced radio I TV techni- cian for help. FCC Caution statement "The User is cautioned that changes or modifications not expre- sely approved by the part responsible for compliance could void the user's authorify to operate the equipment."...
EC DECLARATION OF CONFORMITY Datalogic hereby declares that the apparatus specified below and as referenced in the EC Type Approval Certificate has been tested and found compliant to the following European Council Direc- tives and harmonized Standards. Equipment Type: Handheld Barcode Scanning Equipment...
Page 20
Telephone: 49 (0) 61 51/93 58-0 Telephone: (65) 6435-1311 germany.scanning@datalogic.com singapore.scanning@datalogic.com India Iberia Datalogic Scanning India Datalogic Scanning SAS Sucursal en España Telephone: 91- 22 - 64504739 Telephone: 34 91 746 28 60 india.scanning@datalogic.com spain.scanning@datalogic.com Italy United Kingdom Datalogic Scanning SpA Datalogic Scanning LTD Telephone: [39] (0) 39/62903.1...