Advertisement
13. To prevent accidental tipping during the following
assembly procedures, lower the cart to rest upside
down on its top flanges, so that the wheel support is
facing up. See figure 9.
14. Lay the drawbar tongue (open side facing up) onto
the Wheel Support and the Latch Stand Bracket.
Assemble the axle through the wheel support and the
tongue. See figure 9.
AXLE
FIGURE 9
15. Place the latch lock lever through the slot in the draw
bar tongue as shown in figure 10. Assemble the 5/16"
x 3-3/4" hex bolt through the tongue, the lever and
two 5/16" hex nuts (one on each side of the lever).
Assemble the 5/16" hex lock nut onto the end of the
bolt and tighten so that the bolt can still rotate freely.
Tighten the two 5/16" hex nuts against the sides of
the latch lock lever so that the lever is centered in the
slot. See figure 10.
5/16" x 3-3/4"
HEX BOLT
FIGURE 10
DRAW BAR
TONGUE
LATCH STAND
BRACKET
5/16" HEX NUTS
LATCH
LOCK
LEVER
5/16" HEX
LOCK NUT
16. Hook the short end of the spring into the hole in the
latch lock lever. Use the spring puller tool to hook the
long end of the spring into the square hole in the
tongue. The spring puller tool can be stored when
finished. See figure 11.
SPRING PULLER TOOL
FIGURE 11
IMPORTANT: Make sure drawbar tongue is securely
locked to the latch stand bracket by the latch lock
lever.
17. Place a spacer tube onto each end of the axle
(models 45-01713 & 190-368B only). See figure 12.
18. Assemble a flat washer, a wheel with the valve stem
facing out, and another flat washer onto the axle as
shown in figure 12. Secure the wheel on the axle with
a cotter pin, spreading the ends of the pin around the
axle. Press a hub cap onto the flat washer. Repeat on
other end of axle.
SPACER TUBE
(45-01713 & 190-368B ONLY)
WHEEL
FLAT
WASHER
HUB CAP
COTTER PIN
FIGURE 12
6
LONG END
OF SPRING
LATCH LOCK LEVER
AXLE
FLAT
WASHER
Advertisement
