Seasonal Set-Up; Towing - Jayco 2015 Jay Flight DST Owner's Manual

SECTION 4 TOWING & SET-UP
8. Turn the tongue jack crank to raise the coupler above the hitch ball.
9. Level the RV (front-to-back) with the tongue jack crank.
10. If applicable, lower the stabilizer jacks.
11. Pull the tow vehicle away, as desired.
S S -
EASONAL ET UP
If you are setting up in a seasonal camp site, consult your authorized dealer for
guidelines in properly setting up your travel trailer. Proper set up will insure your
safety along with getting the most effective use from your RV and its features.
You should also familiarize yourself with all site requirements and local zoning
ordinances that may apply.
Set up recommendations
□
The camping site should be properly graded and sloped to prevent water
accumulation under the travel trailer.
□
Make sure all load bearing supports and footings meet the local enforcement
agency requirements for size, capacity and application.
□
Remove grass and organic material from the area beneath any supports or
footings.
Tie-down instructions
All travel trailers should be securely anchored to the ground with 6 tie-downs and
ground anchors (minimum 3 per side), to resist the sliding and overturning effects
of high winds. Where tie-downs are required, it will be necessary to follow the
instructions herein.
Frame tie-down procedure
All travel trailers are equipped with tie-down attachment provisions on the main "I"-
beams (See Fig. 4.6). Any one of the three methods featured may be used.
In the tie-down system, it is important to use materials of proper design and
of adequate quality. The material specifications contained herein should be
considered as minimum requirements.
Materials not furnished with the travel trailer which will be necessary to complete
the tie-down system must meet the requirements set forth below. Such materials
would include:
1. Cable or steel strap with a breaking strength of at least 4,725 pounds, e.g.
galvanized aircraft cable at least 1/4" inch in diameter or Type 1, Finish B
Grade 1 steel strapping, 1 1/4 inches wide and 0.035 inches thick, conforming
with F.S. QQ-S-781-H.
2. Galvanized connection devices such as turnbuckles, eyebolts, strap buckles
and cable clamps should be rated at 3,150 working load minimum.
3.
Ground anchors capable of withstanding at least a 4,725 pound pull. Anchors
must be installed as specified by the
THE UNIT MUST BE IN ITS FINAL LEVEL POSITION PRIOR TO TYING IT
DOWN.
The procedure for tying down the travel trailer is as follows:
1. Position and install the ground anchors to line up with the provided tie-down
brackets.
2. Connect the straps to the frame and ground anchors.
4-16
anchor manufacturer.
JAYCO TOWABLE
JFB/JFD