Table of Contents
Advertisement
Section 4: Vehicle Operation
Vinyl Tire Cover (if so equipped)
Your tires are manufactured with components that cause "bleeding" onto the tire cover. To
prevent this, it is recommended to use a separator (garbage bag, paper, cloth, etc.) between
the tire and the cover.
Seasonal Set-Up
If you are setting up in a seasonal campsite, consult your authorized dealer for guidelines in
properly setting up your travel trailer. Proper set up will insure your safety along with get-
ting the most effective use from your RV and its features.
You should also familiarize yourself with all site requirements and local zoning ordinances
that may apply.
When setting up your seasonal campsite make sure:
The campsite is properly graded and sloped to prevent water accumulation under
the travel trailer.
All load bearing supports and footings meet the local enforcement agency require-
ments for size, capacity and application.
Grass and organic material from the area is removed from under supports or foot-
ings.
Tie-downs
All travel trailers should be securely anchored to the ground with 6 tie-downs and ground
anchors (minimum 3 per side), to resist the sliding and overturning effects of high winds.
Where tie-downs are required, it will be necessary to adhere to the following instructions.
All travel trailers are equipped with tie-down attachment provisions on the main "I"-beams.
Any one of the three methods featured may be used.
In the tie-down system, it is important to use materials of proper design and adequate
quality. The following material specifications should be considered as minimum re-
quirements.
The following materials not furnished with the travel trailer but are necessary to complete
the tie-down system must meet the listed requirements.
1.
Cable or steel strap with a breaking
strength of at least 4,725 pounds, e.g.
galvanized aircraft cable at least 1/4"
inch in diameter or Type 1, Finish B
Grade 1 steel strapping, 1 1/4 inches
wide and 0.035 inches thick, conform
to F.S. QQ-S-781-H.
2.
Galvanized connection devices such
as turnbuckles, eyebolts, strap buckles
and cable clamps should be rated at
3,150 working load minimum.
3.
Ground anchors capable of withstanding at least a 4,725 pound pull. Anchors must be
installed as specified by the anchor manufacturer.
THE UNIT MUST BE IN ITS FINAL LEVEL POSITION PRIOR TO TYING IT
DOWN.
Leveling your recreation vehicle is important as the water drainage systems are designed
with proper slope and must be level for proper operation, and the appliances perform best
when level.
58
Maintenance Record
Table of Contents
Advertisement
Table of Contents
