Jayco 2015 Jay Flight DST Owner's Manual page 94

SECTION 8 - PLUMBING SYSTEMS
The city water connection inlet is located in the utility center. We recommend that
you use a non-toxic drinking water hose dedicated only to supplying the RV with
fresh water (to reduce the chance of contamination, prevent the non-toxic drinking
water hose from coming into contact with the ground). Install the city water
connection inlet cap when the fresh water connection is not being used. Do not
remove the following label from your RV:
The fresh water connection should be unplugged (i.e., the non-toxic drinking water
hose disconnected) when the RV is unattended for any amount of time. If
something would happen to the water system, this may help limit water damage to
a smaller area.
O S
UTSIDE HOWER
A handheld shower assembly with both hot and cold water is available for washing
or rinsing outside the RV.
1. Be sure the water heater is ON and had sufficient time to heat the water.
2. If dry camping, be sure the 12-volt water pump is ON.
3. Open the outside shower compartment door.
4. Remove the hand held showerhead and hose from its holder.
5. Turn ON the hot and cold faucet knobs, and adjust the water temperature as
desired.
6. To activate the hand held shower turn ON the sprayer head attachment
(some models. Open the faucet knobs and adjust them to the desired
temperature.
To cease operation, close the faucet knobs. After the water has been allowed to
drain from the shower head, replace it in the outside shower compartment. Any
remaining water in the shower hose will drip or run out; this is not a leak but
performs as intended.
The showerhead can be removed to drain the hose faster. If you choose to
remove the showerhead to drain the hose, reassemble it for storage. Coil the hose
and arrange it with the showerhead inside the faucet assembly. Make sure that the
hose is not being pinched and the showerhead is not being damaged when the
door is closed.
8-8
Fig. 8.7 Potable water only label
(I S E
F O QUIPPED
)
JAYCO TOWABLE