Power Source - Porter-Cable US58 Instruction Manual

O P E R ATING INSTRUCTIONS
F O R E W O R D
Porter-Cable Model US58 is a pneumatic upholstery stapler. I t i s d e s i g n e d t o
3
i n s ta l l " crown, 22 gauge, wire staples of various lengths (
...
8
see ACCESSORIES Listing in back of this manual).

POWER SOURCE

This tool is designed to operate on clean, dry, compressed air at regulated
pressures between 60 and 100 PSI (Pounds per Square Inch). The preferred
system would include a filter, a pressure regulator, and an automatic oiler located
a s c l o s e t o t h e t o o l a s p o s s i b l e ( w i t h i n 1 5 f e e t i s i d e a l ) .
All compressed air contains moisture and other contaminates that are
detrimental to internal components o f t h e t o o l . A n a i r l i n e f i l t e r w i l l r e m o v e m o s t
of these conta m i n a t e s a n d s i g n i f i c a n t l y p r o l o n g t h e l i f e o f t h e t o o l . I f a n i n - l i n e
oiler is not available: place one or two drops of Porter-Cable A i r To o l O i l ( s e e
ACCESSORIES), into the tool s air inlet at the beginning of each workday.
The tool is equipped with a male quick connector . The tool must always be
connected to the air supply with a coupling such that all pressure is removed
from the tool when the coupling is disconnected.
CAUTION: All air line components (hoses, connectors, filters,
regulators, etc.) must have a minimum working pressure rating of
150 PSI (10.3 BAR) or 150% of maximum system potential,
whichever is higher.
Do not connect this tool to a system with maximum potential pressure
greater than 200 PSI.
Only connect tool to air supply with a coupling that will release all
pressure from the tool when disconnected.
Disconnect tool from air supply before performing maintenance,
clearing a jammed fastener, leaving work area, moving tool to another
location, or handing the tool to another person.
Fig. 14 Fig. 15
5
1 5
" t o " l o n g ,
... ...
4 8