How To Set Remote Control Selector Switch - Toshiba RAS-10GKHP-E Service Manual

8-6. How to Set Remote Control Selector
Switch
When two indoor units ae installed in seperated rooms,
there is no need to change the selector switch.
<Remote control selector switch>
·
When two indoor units are installed in the same
room or the adjacent two rooms, they may be
controlled simultaneously with a single remote
control. To prevent this, set either unit and its
remote control to B setting. (Both units are set to A
setting before shipment.)
· The remote control signal is not recived when the
indoor unit setting is different from the remote
control one.
1. Set the remote control selector switch with the
indoor unit.
1) Turn the circuit breaker of the main power switch off
before setting the selector switch.
2) Remove the Air inlet grille and Front panel. (Refer to
10-1)
3) Select the terminal of selector switch from
[A position] to [B position].
How to set the remote control selector switch
A setting
A B
F ig. 8-6-1
Remote control selector switch
B setting
A B
− 48 −
FILE NO. SVM-06037