Toshiba RAS-10GKHP-E Service Manual page 32

7-8-2. How to cancel auto restart function
To cancel auto restart function, proceed as follows:
Repeat the setting prodedure: the unit receives the
signal and beeps three times.
The unit will be required to be turned on with the
remote control after the main power supply is turned
off.
When the unit is on standby (Not operating)
Operation
Push [RESET] button for more
than three seconds.
RESET button
When the unit is in operation
Operation
Push [RESET] button for more
than three seconds.
RESET button
·
While this function is being set, if the unit is in
operation, the orange lamp is on.
7-8-3. Power failure during timer operation
When the unit is in Timer operation, if it is turned off
because of power failure, the timer operation is
cancelled. Therefore, set the timer operation again.
The unit is on standby.
¯
The unit starts to operate.
¯
The unit beeps three times
and continues to operate.
¯
0
3S
If the unit is not required to operate at this time, push [RESET]
button once more or use the remote control to turn it off.
The unit is in operation.
¯
The unit stops operating.
¯
The unit beeps three times
0
3S
If the unit is required to operate at this time, push [RESET]
button once more or use the remote control to turn it on.
- 31 -
FILE NO. SVM-06037
Motions
The orange lamp is on.
After approx. three seconds,
The lamp changes from
orange to green.
Motions
The orange lamp is on.
The orange lamp is turned off.
After approx. three seconds,