Recording; Basic Recording For Video - JVC GR-DVL505 Instructions Manual

16
EN
Power Switch
Power lamp

Recording

Start/Stop Button
Display
min 90 min
(Now calculating)
0 min
(Blinking)
Tally lamp
(lights while recording
is in progress)
BR I GHT –
180 90
PUSH OPEN Button
Lock Button
During
shooting
2 5
Tape remaining
time indicator
(Approximate)
89 min 3 min
1 min 2 min
(Blinking) (Blinking)
MENU/
BRIGHT Wheel
+
VIDEO/DSC Switch
RECORDING
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
Power ( pg. 8)
Grip Adjustment (
Viewfinder Adjustment (
Load A Cassette (
Recording Mode Setting (
1
Press in the tabs on the lens cap to remove it. Press
PUSH OPEN, open the LCD monitor and set the
VIDEO/DSC Switch to "VIDEO".
2
Set the Power Switch to "
down the Lock Button located on the switch.
Shooting while using the LCD monitor: Make sure
the LCD monitor is fully open. Tilt it upward/
downward for best viewability.
Shooting while using the viewfinder: Close the LCD
monitor.
•The power lamp lights and the camcorder enters the
Record-Standby mode. "PAUSE" is displayed.
3
Press the Recording Start/Stop Button. "
while recording is in progress.
To Stop Recording . . .
.... press the Recording Start/Stop Button. The camcorder
re-enters the Record-Standby mode.
To Adjust The Brightness Of The Display
.... rotate the MENU/BRIGHT wheel until the bright level
indicator on the display moves and the appropriate
brightness is reached.
•If you are using the GR-DVL805, it is also possible to
adjust the brightness of the viewfinder by closing the
LCD monitor and adjusting as described above.

Basic Recording For Video

pg. 10)
pg. 10)
pg. 12)
pg. 13)
" or " " while pressing
" appears