Random Assemble Editing - JVC GR-DVL210 Instructions Manual

44
EN
Program
N I OUT
1 – – – – : – – ~
2 ~
3 ~
4 ~
5 ~
6 ~
7 ~
8 ~
T I ME CODE – – : – –
TOTAL 0 0 : 00
Remote sensor
REW
PLAY
IN/OUT
CANCEL
RM-V700U
USING THE REMOTE CONTROL UNIT
MODE
Random Assemble
Editing Menu
FF
ON/OFF
(optional)
SELECT SCENES
4
Point the remote control at the camcorder's remote
sensor. Press PLAY (4) and then press ON/OFF on
the remote control. The Random Assemble Editing
Menu appears.
5
At the beginning of the scene, press IN/OUT on the
remote control. The Edit-In position appears in the
Random Assemble Editing Menu.
6
At the end of the scene, press IN/OUT. The Edit-Out
position appears in the Random Assemble Editing
Menu.
7
Repeat steps 5 and 6 to register additional scenes.
•To change previously registered points, press
CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
NOTES:
When choosing a scene, set Edit-In and Edit-Out points
so that there is a relatively large difference between
them.
If the search time for an in-point exceeds 5 minutes, the
recording deck's Record-Standby mode will be canceled
and editing will not take place.
If there are blank portions before or after the Edit-In and
Edit-Out points, a blue screen may be included in the
edited version.
Since time codes register time only as accurately as
seconds, the time code total time may not match the
total program time exactly.
Turning off the camcorder's power erases all registered
Edit-In and Edit-Out points.
(cont.)