JVC GR-DVL210 Instructions Manual page 33

TELE
OFF
MACRO
ON
WIDE
OFF
MODE
CINEMA
SQUEEZE
OFF
WIND
CUT
ON
OFF
BEEP
BEEP
MELODY
OFF
TALLY
ON
This number is necessary when connecting the camcorder to a device such as a computer
ID
using the J terminal (JLIP). The numbers range from 01 to 99. Factory setting is 06.
NUMBER
: Factory-preset
NOTES:
The " MANUAL" settings are effective only when the Power Switch is set to " ".
" SYSTEM" functions which are set when the Power Switch is set to "
Power Switch is set to "
Usually the distance to a subject where the lens is in focus depends on the
zoom magnification. Unless there is a distance more than 1m (3.3 ft.) to the
subject, the lens is out of focus at the maximum telephoto setting. When set
to "ON", you can shoot a subject as large as possible at a distance of approx.
60 cm (2 ft.).
•Depending on the zoom position, the lens may go out of focus.
Records with no change in the screen ratio. For playback on a TV with a
normal screen ratio.
Inserts black bands at the top and bottom of the screen. During playback on
wide-screen TVs, the black bands at the top and bottom of the screen are cut
and the screen ratio becomes 16:9.
to your wide-screen TV's instruction manual. During playback/recording on
4:3 TVs/LCD monitor/viewfinder, black bands are inserted at the top and
bottom of the screen and the image appears like a letterboxed 16:9 movie.
For playback on TVs with an aspect ratio of 16:9. Naturally expands the
image to fit the screen without distortion.
mode, refer to your wide-screen TV's instruction manual. During playback/
recording on 4:3 TVs/LCD monitor/viewfinder, the image is elongated
vertically.
Disengages the function which cuts down on noise created by wind.
Helps cut down on noise created by wind. "
sound will change. This is normal. Even though not heard while shooting,
shutter sound is recorded on the tape.
Even though not heard while shooting, shutter sound is recorded on the tape.
The beep sounds when the power is turned on or off, and at the beginning and end
of recording. Also to activate the shutter sound effect (
Instead of a beep, a melody sounds when any operation is performed. It also
activates the shutter sound effect (
The tally lamp remains off at all times.
The tally lamp comes on to signal the start of recording.
" ( pg. 35).
appears. When using this mode, refer
appears. When using this
" appears. The quality of the
pg. 23).
pg. 23).
" are also applied when the
CONTINUED ON NEXT PAGE
33
EN