Yamaha YZFR1Y(C) 2009 Service Manual page 59

Item
Front wheel axle pinch bolt
Rider footrest bolt
Passenger footrest bolt
Rear frame lower reinforcement
and passenger footrest bolt
Rear brake master cylinder bolt
Rear brake hose union bolt
Sidestand bracket bolt
Battery box bolt
Lean angle sensor bolt
License plate/turn signal light stay
bolt
License plate/turn signal light bolt
Exhaust chamber cover bolt
TIP
Lower ring nut
1. First, tighten the lower ring nut approximately 52 Nm (5.2 m·kgf, 37 ft·lbf) by using the torque
wrench, then loosen the ring nut completely.
2. Retighten the lower ring nut 18 Nm (1.8 m·kgf, 13 ft·lbf).
TIP
Lower bracket pinch bolt
Tighten each bolt to 23 Nm (2.3 m·kgf, 17 ft·lbf) in the order pinch bolt "1" → pinch bolt "2" → pinch
bolt "1" → pinch bolt "2".
TIP
Front wheel axle pinch bolt
1. Insert the front wheel axle from the right side and tighten it with the flange bolt from the left side
to 91 Nm (9.1 m·kgf, 66 ft·lbf).
2. In the order from the pinch bolt "2" → pinch bolt "1" → pinch bolt "2", tighten each bolt to 21 Nm
(2.1 m·kgf, 15 ft·lbf) without performing temporary tightening.
3. Check that the end face of the axle head and the end face of the fork side are flush-mounted.
If they are out of alignment, make sure to fit them by adding the external force by hand or with a
plastic hammer, etc.
If the end face of the axle is not parallel to the end face of the fork, align them so that one point
of the axle circumference is positioned on the end face of the fork.
Thread
Q'ty
size
M8 4 21 Nm (2.1 m·kgf, 15 ft·lbf)
M8 4 28 Nm (2.8 m·kgf, 20 ft·lbf)
M8 4 28 Nm (2.8 m·kgf, 20 ft·lbf)
M6 2 13 Nm (1.3 m·kgf, 9.4 ft·lbf)
M6 2 13 Nm (1.3 m·kgf, 9.4 ft·lbf)
M10 2 30 Nm (3.0 m·kgf, 22 ft·lbf)
M10 2 63 Nm (6.3 m·kgf, 45 ft·lbf)
M6 2 7 Nm (0.7 m·kgf, 5.1 ft·lbf)
M4 2 2 Nm (0.2 m·kgf, 1.4 ft·lbf)
M6 3 7 Nm (0.7 m·kgf, 5.1 ft·lbf)
M6 4 10 Nm (1.0 m·kgf, 7.2 ft·lbf)
M6 2 7 Nm (0.7 m·kgf, 5.1 ft·lbf)
2-22
TIGHTENING TORQUES
Tightening torque Remarks
See TIP.
LT
LT
LT