Yamaha YZFR1Y(C) 2009 Service Manual page 22

This mode allows you to make changes to six
settings by performing the following steps.
1. Turn the key to "OFF".
2. Push and hold the "SELECT" button.
3. Turn the key to "ON", and then release the
"SELECT" button after five seconds. The
display brightness function is selected.
4. Push the "SELECT" button to switch the
functions in the order below.
a. Display brightness:
This function allows you to adjust the
brightness of the displays and tachome-
ter to suit the outside lighting condi-
tions.
b. Shift timing indicator light activity:
This function allows you to choose
whether or not the indicator light should
be activated and whether it should flash
or stay on when activated.
c. Shift timing indicator light activation:
This function allows you to select the
engine speed at which the indicator
light is activated.
d. Shift timing indicator light deactivation:
This function allows you to select the
engine speed at which the indicator
light is deactivated.
e. Shift timing indicator light brightness:
This function allows you to adjust the
brightness of the indicator light to suit
your preference.
f. Throttle opening position display:
This function allows you to choose
whether or not to show the throttle
opening position display.
TIP
The display shows the current setting for each
function, except the shift timing indicator light
activity function.
To adjust the brightness of the multifunction
meter displays and tachometer
1. Turn the key to "OFF".
2. Push and hold the "SELECT" button.
3. Turn the key to "ON", and then release the
"SELECT" button after five seconds.
4. Push the "RESET" button to select the
desired brightness level.
5. Push the "SELECT" button to confirm the
selected brightness level. The control
mode changes to the shift timing indicator
light activity function.
To set the shift timing indicator light activity
function
1. Push the "RESET" button to select one of
the following indicator light activity settings:
• The indicator light stays on when acti-
vated. (This setting is selected when the
indicator light stays on.)
• The indicator light flashes when acti-
vated. (This setting is selected when the
indicator light flashes four times per sec-
ond.)
• The indicator light is deactivated; in other
words, it does not come on or flash. (This
setting is selected when the indicator light
flashes once every two seconds.)
2. Push the "SELECT" button to confirm the
selected indicator light activity. The control
mode changes to the shift timing indicator
light activation function.
To set the shift timing indicator light activation
function
TIP
The shift timing indicator light activation func-
tion can be set between 7000 r/min and 15000
r/min. From 7000 r/min to 12000 r/min, the indi-
cator light can be set in increments of 500 r/
min. From 12000 r/min to 15000 r/min, the indi-
cator light can be set in increments of 200 r/
min.
1. Push the "RESET" button to select the
desired engine speed for activating the
indicator light.
2. Push the "SELECT" button to confirm the
selected engine speed. The control mode
changes to the shift timing indicator light
deactivation function.
To set the shift timing indicator light deactiva-
tion function
TIP
• The shift timing indicator light deactivation
function can be set between 7000 r/min and
15000 r/min. From 7000 r/min to 12000 r/
min, the indicator light can be set in incre-
ments of 500 r/min. From 12000 r/min to
15000 r/min, the indicator light can be set in
increments of 200 r/min.
• Be sure to set the deactivation function to a
higher engine speed than for the activation
1-13
FEATURES