Table of Contents
Advertisement
o Tilt the appliance backward at a maximum angle of 35°. Unscrew
the leg support screws (C) - left and right, and remove the leg
support cover (D). Then place it on the opposite side.
o Unscrew, remove and then replace the position of the end switch
(E) and decorative peg (F) (for models with forced door closing
system).
o Unscrew the three screws fixing the bottom hinge and then fix
the bottom hinge on the opposite side.
o To fit the door on the opposite side of the freezer proceed with
the above procedure in reverse.
Troubleshooting
IMPORTANT: If your refrigerator appears not to be
operating properly, before contacting the Baumatic
Service Department, please refer to the checklist
below.
My fridge does not appear to be working/there is no
power to my appliance.
o Check that the plug is fully inserted into the power socket.
o Check that there is power to your mains supply (e.g. that there
hasn't been a power cut or that the fuse hasn't blown).
o Check that the thermostat inside the appliance has not been
turned to the off position.
o Check that your mains supply voltage, corresponds to the
voltage stated on the rating plate of your appliance.
My fridge appears to be performing poorly
o Check that the appliance isn't overloaded and that food hasn't
been packed too tightly into it.
20
Advertisement
Table of Contents
