Table of Contents
Advertisement
Positioning
o It is advisable that your appliance is only installed in a location
where the ambient temperature of the room, corresponds with
the climate classification that is stated on the rating plate of your
appliance. Your appliance may not function correctly if the
ambient temperature falls outside of the following ranges.
Climate classification Appropriate ambient temperature
SN
N
ST
T
o Positioning the appliance requires two persons in order to avoid
injuries or damage to the appliance.
o Your appliance should not be located in direct sunlight or
exposed to continuous heat or extremes of temperature (e.g.
next to a radiator or boiler).
o You should check whether there is an electrical socket available,
which will be accessible after your appliance is installed.
o Place the appliance flatly and firmly on a solid base. The
appliance is fitted with adjustable feet on the front side, used to
level the appliance.
o The rear side of the appliance is fitted with wheels which
facilitate the positioning of the appliance into its final location.
o Anything positioned above the appliance must be at least 5 cm
away to allow sufficient cooling of the condenser. You must allow
a 15mm gap to the rear of the appliance.
o Avoid exposing the appliance to direct sunlight or heat sources.
If this is not feasible, then you should install an insulation plate
between the appliance and the adjacent heat source.
o The bottom front corners of your appliance are fitted with
handles to facilitate moving. The appliance may stand
independently or adjacent to a cupboard or wall.
o Be sure to leave enough space for the opening of the door, to
avoid damage to the appliance or personal injury. Also leave
ample space for extracting shelves. (see diagram on the next
page).
+10 to +32 degrees centigrade
+16 to +32 degrees centigrade
+10 to +38 degrees centigrade
+18 to +43 degrees centigrade
17
Advertisement
Table of Contents
