Installation Overview - Enterasys X-Pedition XSR-1805 Getting Started Manual

Installation Overview

• Switched PPP Multilink connections
• Backup using ISDN & MLPPP connections
• Dialer interface spoofing
• Dialer watch
Installation Overview
Installing the XSR consists of performing the following general steps. For detailed instructions,
refer to Chapters 2 and 3 of this manual.
1. Unpack the XSR from the shipping box. Remove accessories.
Items included in the shipping box are shown in Chapter 2 of this manual. If you are missing
any of these items, contact your authorized Enterasys Networks reseller or Enterasys
Networks Customer Support as described in the Quick Start Guide.
Cabling is not supplied with the XSR. Please refer to Appendix A for part numbers and contact
your Enterasys Networks sales representative.
2. Install any optional memory component.
3. Install NIM cards.
4. Optional. Mount the XSR in a rack or the custom Enterasys rack-mount kit (refer to the XSR-
1805 Rack-Mount Kit Manual for details).
5. Connect Ethernet cable(s) to the FastEthernet LAN port(s).
6. Do one or more of the following:
• Connect a NIM cable, attaching one end to the RJ-xx port on the NIM card and the other to
• Connect the serial cable to the High Speed serial port, attaching one end to the 68-pin, SCSI
• Connect all other NIM cables.
7. Connect the supplied Console serial cable, attaching the female end to the Console port of the
XSR and the other end to the DB-9 serial port on your terminal or PC.
8. Connect the appropriate end of the power supply cord to the connector at the back of the XSR.
Attach one end of the country-specific power cord to the power supply and plug the other end
into a wall socket.
Once the XSR is connected, you can begin software configuration, which is described in Chapter 3.
1-10 Overview
a network connector/hub.
III type connector on the NIM card and the other end to a network device.