Installing Shunt/Terminal Strip - Enterasys X-Pedition XSR-1805 Getting Started Manual
Security router
Hide thumbs
Also See for X-Pedition XSR-1805:
- Getting started manual (106 pages) ,
- Owner's manual (25 pages) ,
- Configuration manual (55 pages)
Table of Contents
Advertisement
Cable, CompactFlash and Accessory Specifications
Installing Shunt/Terminal Strip
To install the shunt or terminal strip, attach two dual-pin units vertically to each four-pin jumper
(P2, P3, P4, or P5) corresponding to the RJ-48C port using a balun, as shown in
Figure
A-16. Any
other RJ-48C5 ports on the NIM card connected to 120-ohm lines do not require shunts.
Figure A-16
Installing a Grounding Shunt on the E1 NIM Card
XSR Getting Started Guide A-75
Advertisement
Table of Contents
