Bleed Brake System (Workman E2065) - Toro WorkmanR e2050 Service Manual

Bleed Brake System (Workman e2065)

1. Connect a suitable transparent hose to bleeder valve
on a wheel cylinder or caliper. Submerge other end of
hose in a glass container partially filled with clean brake
fluid.
2. Have a helper pump brake pedal several times, then
hold pedal down firmly.
3. With pedal firmly depressed, open bleeder valve un-
til pedal fades to floor. Close bleeder valve before re-
leasing pedal.
4. Repeat procedure until a continuous flow of brake
fluid, with no air bubbles, is released from bleeder valve.
Make sure fluid level is maintained in brake fluid res-
ervoir at all times.
Workman e2050/e2065
5. Repeat steps 1 to 4 for other brake cylinders and cali-
pers.
After servicing the brakes, always check the
brakes in a wide open, level area that is free of
other persons and obstructions.
6. After bleeding of brakes is completed, test vehicle to
make sure brakes are operating correctly and brake
pedal is solid.
Page 4 – 15
CAUTION
Transaxle and Brakes (Rev. B)