Next Steps - Dell DF10MXL Getting Started Manual

Networking mxl 10/ 40gbe switch io module

Table of Contents

Next Steps

If you installed the MXL 10/40GbE Switch in a stack, you can configure

additional settings for switch stacking.

For information about how to create different stacking scenarios, refer to the

Ethernet Stacking white paper on the Dell Support and Dell Networking

White Papers websites at:

http://support.dell.com/manuals

http://en.community.dell.com/techcenter/networking/w/wiki/networking-

whitepapers.aspx

For information about how to configure stacking, refer to the Configuration

Guide for the Dell Networking MXL 10/40 GbE Switch IO Module on the Dell

Support website at http://support.dell.com/manuals.

•

You can customize the MXL 10/40GbE Switch for use in your data center

network by configuring software features as necessary. To perform

additional switch configuration, do one of the following:

•

For remote out-of-band management, enter the OOB management

interface IP address into a Telnet or SSH client and log in to the

switch using the user ID and password to access the CLI.

•

For local management, use the attached console connection to log in

to the CLI.

•

For remote in-band management from a network management

station, enter the IP address of the default virtual local area network

(VLAN) and log in to the switch to access the CLI.

For information about how to configure software settings, refer to the

Configuration Guide for the Dell Networking MXL 10/40 GbE Switch IO

Module on the Dell Support website at http://support.dell.com/manuals.

Next Steps

Table of Contents