Next Steps - Dell PowerEdge M I/O Aggregator Getting Started Manual

Next Steps

• You can customize the Aggregator for use in your data center network as
necessary. To perform additional switch configuration, do one of the
following:
• For remote out-of-band management, enter the OOB management
interface IP address into a Telnet or SSH client and log in to the
switch using the user ID and password to access the CLI.
• For local management using the CLI, use the attached console
connection.
• For remote in-band management from a network management
station, enter the VLAN IP address of the management port and log in
to the switch to access the CLI.
• If you installed the Aggregator in a stack, you can configure additional
settings for switch stacking.
• In case of an FTOS upgrade, you can check to see that an Aggregator is
running the latest FTOS version by entering the show version command.
To download an FTOS version, go to http://support.dell.com.
For information about how to configure software features, refer to the User's
Configuration Guide for the PowerEdge M I/O Aggregator on the Dell Support
website at http://support.dell.com/manuals.
34
Next Steps