Tape Dubbing - JVC GR-AXM240 Instructions Manual

Connections To A TV/VCR
1) Make sure all units are turned off.
2) Connect the camcorder to a TV or VCR using
optional video and audio cables. If using both
TV and VCR, connect the VCR output to the TV
input.
3) Turn on all units. Set the VCR to its AUX input
mode, and set the TV to its VIDEO mode.
• Use the AC Adapter as the power supply.
• The S-Video cable connection can improve the
dubbed picture quality. An optional S-Video cable
is required (GR-SXM740/SXM540/SXM340/
SX970 only).
• Be sure to adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
• If you have a TV or speakers that are not
specially shielded, do not place the speakers
adjacent to the TV as interference will occur in the
camcorder playback picture.
To S-Video
5
Output
Connector cover
S-Video cable
To S-Video
Input
White to
Audio
Output
Yellow to
Video Output
A/V cable
TV To TV or VCR
White to
Audio Input
VCR
Yellow to
Video Input

Tape Dubbing

1) Connect the camcorder and the VCR
( "Connections To A TV/VCR"). Set the Power
@
Switch
and insert the appropriate cassettes in the
camcorder and the VCR. Engage the VCR's
AUX and Record-Pause modes.
2) Press 4/6
in point. Once it is reached, press 4/6
3) Press 4/6
mode.
4) Engage the VCR's Record-Pause mode and
press 4/6
• Repeat steps 2) through 4) for additional editing,
then stop the VCR and camcorder when finished.
6
7
15
to " ", turn on the VCR's power,
^
to find a spot just before the edit-
^
and engage the VCR's Record
^
.
^
again.